The HT-GC310 has all required features for the most common generator applications (Single Prime Mover and Single Stand-by). Read more....

This is an advanced and integrated controller for generator sets operating in single stand-by mode, particularly aimed for giving high performance benefits.

In addition to the features of the HT-GC310 controller the HT-GC350 is equipped with an expansion I/O module which allows its use in customized and non-standard applications. Read More...

HT-GC500 is an advanced and self-contained controller which is particularly suitable for groups of up to 16 gensets running in parallel, with or without Mains.

This controller has been designed to simplify installation and operation due to its internal Load Sharing (by CAN interface), Synchronizer (via CAN or PWM output) and VAr regulation. Read more...

The HT-DST4601/PX is a highly configurable genset controller designed to handle a broad range of critical and complex parallel applications, including multiple Mains and CHP systems.

The controller can, synchronize to a wide variety of 3rd party/existing systems using an analogue synchronizing signal.

It is a well specified device, featuring generator protections, engine protections and monitoring, fuel pump management, real time clock, serial communication and direct analogue and GSM modem interface capability. Read more...

The HT-MC100 controller is designed to manage multiple parallel systems. The unit is able to control the global circuit breaker and generator functions operating as a Master unit. Read more...

CAN BRIDGE, allows to extend the bus, both in generator numbers and bus length. It filters all not needed messages, separating the internal communication from the external. It can acquire measure from auxiliary devices by 2 additional MODBUS lines.

ROUTER GSM, allows using a single GSM modem for systems that use more than one controller. It also allows local communication to a supervisor system, SMS communications and alert support. It’s possibility to add up to 2 Mbytes of battery backup RAM for data recording.

MODBUS TCP/RTU gateway is uses to connect one or more Modbus RTU devices to the Ethernet. It can manage up to 32 RTU server (slave) devices.

PWM Converter, is a two channel insulated PWM to Current-Loop converter. Both channels are identical and independent, and can be freely used for both AVR or Governor interface (or other application).

DITEL, are I/O (input/output) modules used for Hügli Tech controllers expansion and as generic MODBUS I/O expander. The base module has 16 digital inputs. Up to two output modules, each of 8 outputs can be attached to the base module.

DIPOT, (Digital Potentiometer) is an electronic device micro controlled, capable to generate a current loop output signal, up to +/- 20mA controlled by digital inputs, or remotely via Modbus RTU standard protocol (by use of internal RS485 interface).

It has different operation modes:

• stand-alone UP-DOWN to Current-Loop converter.
• stand-alone voltage to Current-Loop converter and insulator

ECU simulator: support J1939 protocol receiving Speed Reference that transfer to the governor by Current-Loop output; measures and transfer to the controller both OIL PRESSURE and COOLANT TEMPERATURE by means VDO sensors.

DITHERM, is a thermocouple interfaces with 3 channels (supported thermocouples: B,R,S,J,E,N,K,T)

DIGRIN, is a PT100 interface with 3 channels. (temperature range -70°C +650°C)

DIVIT, is the analogue input module.

It has 4 configurable inputs, each for 0..5V, 0..10V, 0..10mA and 0..20mA (active or passive) input, and all are galvanic isolated.

DANAOUT, is the analogue output module.

It has 4 configurable outputs, each for 0..5V, 0..10V, 0..10mA and 0..20mA (active or passive) output, and all are galvanic isolated.