HT-GC500 Multiple paralleling genset control

HT-GC500 Multiple paralleling genset control

HT-GC500 is an advanced and self-contained controller is which particularly suitable for groups of up to 16 gensets running in parallel, with or without Mains.

Features

  • 3-phase AMF automatic genset controller with soft return
  • In-built paralleling and load sharing for up to 16 gensets
  • 18+3 fully programmable digital inputs
  • 15 programmable digital outputs
  • RS232 (9-pin D-Sub) port with Modbus RTU protocol
  • Additional RS232 or RS485, 4-wire serial port
  • J1939 and MTU MDEC CAN interface
  • Real Time Clock
  • Events and data logging
  • GSM and PSTN modem management
  • SMS communication

Benefits

  • Simple installation and operation due to its internal Load Sharing (by CAN interface), Synchronizer (via CAN or PWM output) and VAr regula­tion
  • Communication directly via J1939 CAN interface with a wide range of electronic engines (Volvo Penta, Scania, Perkins, MTU, Deutz, Cummins, John Deere, Caterpillar etc.)
  • For conventional engines / sensors thanks to its embedded analogue interfaces
  • This controller is a complete solution in one unit: generator protections, engine protections / monitoring, fuel pump management, real time clock, serial communication and direct PSTN and GSM modem interface capability
  • HT-GC500 has a 4 wire RS232 or RS485 serial port for I/O expansion and it allows the con­nection of the ‘Gateway Modbus TCP/RTU’ module Ethernet interface

Software

Software 1

Application / Picture Gallery