HT-GC500plus Multiple paralleling genset control with internal load sharing and synchronizing

HT-GC500plus Multiple paralleling genset control with internal load sharing and synchronizing

HT-GC500plus is a complete solution in one unit; with engine, generator and mains protection/monitoring, fuel pump management, real time clock, serial communication and direct PSTN and GSM modem interface capability.

Now with digital UP/DOWN command for speed governor and AVR.

Features

  • Three-phase AMF automatic genset controller
  • In-built paralleling and load sharing for up to 16 gensets
  • 2 analogue insulated voltage outputs (for AVR and SPEED GOVERNOR)
  • PNM direct interface with CATERPILLAR, PERKINS and gensets with similar regulation systems
  • 18+3 configurable digital inputs
  • 15 configurable digital outputs
  • RS232 (9-pin D-Sub) port with Modbus RTU protocol
  • Additional RS232 or RS485, 4-wire serial port
  • J1939 and MTU MDEC CAN interface
  • Events and data logging (RTC)
  • GSM and PSTN modem management
  • SMS communication

Benefits

  • Simple installation and operation due to its internal Load Sharing (by CAN interface), Synchronizer (via CAN or PWM output) and VAr regulation
  • Communication directly via J1939 CAN interface with a wide range of electronic engines (Volvo Penta, Scania, Perkins, MTU, Deutz, Cummins, John Deere, Caterpillar etc.)
  • For conventional engines / sensors, thanks to its embedded analogue interfaces
  • This controller is a complete solution in one unit: generator protections, engine protections / monitoring, fuel pump management, real time clock, serial communication and direct PSTN and GSM modem interface capability
  • HT-GC500plus has 2 analogue insulated voltage outputs (for AVR and SPEED GOVERNOR)

Documentation

Brochures

Datasheets

Software

Software 1

Application / Picture Gallery