HT-SG-200 - Speed Control Unit - InGovern Series
The HT-SG-200 is an electronic speed governor for conventional diesel engines. Its digital processing not only provides flexibility in configuration but also allows CAN J1939 data exchange with many modern controllers.
The unit will internally convert the signal from a standard inductive flywheel pick-up to an RPM value, display it on the 4-digit LED display and also send it as a standard J1939 value to a connected controller.
The HT-SG-200 is supplied pre-configured and once the number of flywheel teeth is input (1 x press of [Fn] button then [+] or [-] until the correct value is displayed) then the engine will run. All parameters are stored in non-volatile memory.
Features
Supply 12/24V
Speedrange 300 - 8000Hz
Number of teeth on flywheel 50-255
Adjust Actuator Output
5VDC Terminal
Save configurations file to disc
Load configurations file from disc
Binary Speed up/down
Position mode
Speed and function Display on device
GUI for Windows XP / 7 / 8 / 8.1 / 10 / 11
Speed display on GUI
Actuator output Duty cycle display on GUI
Speed control voltage display on GUI
Big screen PID control on GUI
Wiring display on GUI
Default configuration settings
Benefits
IP65 sealed
Bi-directional CAN Bus enabled
Clear LED Display (RPM default)
Simple 3-button Interface
RPM sent as std. J1939 value
Idle speed
Overspeed Protection
Sent as std J1939 FMI code
Speed Ramp
Fuel Ramp
Crank Termination
Start Fuel Position
Fuel Limit
2 Speeds